Pinpointe Web Analysis


Quality Control & Parts Diverting Systems

Turntable Part Diverter

Shot Rejection Conveyor

Eliminate the need to manually inspect and remove bad parts. As parts enter the turntable, they travel around the edges until they reach the diverter. The diverter moves them to the center of the table where they can accumulate. New parts enter the turntable without dropping onto parts that are already there.

These variable-speed turntables are available in five diameters and heights from 28"–34". Ideal end-of-belt work station for accumulating, sorting, finishing or packing molded parts. The rotating table and 6" side rails are lined with FDA approved white PVC belting material to protect your parts. Drive motor is behind protective metal guard. Optional castors allow moving the turntables anywhere they're needed in the plant.

How does it work? On one side of the diverter is a panel which is hinged on the bottom. If a bad part is molded, a Process Control Tie-In signals two air cylinders to activate. The cylinders push the top of the hinged side panel under the mold, creating a chute to remove the bad parts. Once the parts are removed, the panel immediately returns to the upright position, which allows the next shot of parts to fall onto the conveyor.

Features:

  • 12-gauge steel construction
  • 1/3 hp, 110/60/1 DC variable-speed drive
  • Shipped with electrical components completely installed and wired
  • Control wiring is contained in liquid-tight conduit and connectors
  • Common Options:

  • Stationary outer ring: only table surface rotates
  • Castors, to ensure ease of movement
  • Stainless steel construction
  • Tapered stainless steel cones for part distribution