5038 Gimatic Quick Changer Large Size (150mm), EOAT Side

This quick changer accessory connects electrical signals from the EOAT to the robot. It has 15 pin gold plated SUB D connectors and comes complete with mounting hardware.

I/O Connection Type: 15-pin D-Sub, VGA type Cable.

This quick changer accessory connects electrical signals from the EOAT to the robot. It has 15 pin gold plated SUB D connectors and comes complete with mounting hardware.

I/O Connection Type: 15-pin D-Sub, VGA type Cable.

Typically used when the injection molding machine is over 750 tons, this plate is designed to mount large/jumbo >ASS<, Gimatic, and 80/20 four- and six-groove profiles (80mmx40mm) as well as all standard four- and six-groove >ASS<, Gimatic, and 80/20 profiles. It is pre-drilled to mount to the large EOAT quick changer. The counter-bored holes provide flush mounting surfaces on both sides. And it can also be used as a manual mounting plate to the robot.

This anodized aluminum plate can be used as a manual EOAT mounting plate to adapt profiles. It's scored with a center line making it easy to locate holes for mounting to your robot tooling plate.

Thin-plate interface to mount EOAT side quick changer to Gimatic, >ASS<, and 80/20 profiles. Fasteners and mounting screws are included.

For horizontal wall mounting and storage of EOAT's

This centering pin helps the manual centering of heavy EOAT's

For vertical wall mounting and storage of EOAT's

Quick changers assure the EOAT will be perfectly positioned each time it's mounted to the robot. In addition to helping to prevent damage to the mold or the EOAT, this can also greatly reduce the amount of fine-tuning needed upon set up. Using a quick changer that automatically connects air, vacuum and electrical assures that each time the EOAT is mounted, all of the connections will be correct (i.e. primary vacuum, secondary vacuum, primary air, secondary air etc.).