S2K Commerce - Products Dropdown

Actions
Loading...

S2K Commerce - Shopping Cart

Actions
Loading...

S2K Commerce - Order Entry

Actions
Loading...
Home  >  End-of-Arm Tooling  >  Sensors  >  Sensors  > 7526 Gimatic Teachable C-Slot PNP Sensor with M8 Connector

7526 Gimatic Teachable C-Slot PNP Sensor with M8 Connector SN Style

Item #:PRO SN3N215G 
Available: In Stock

Gimatic PRO-SN sensors are digital magnetoresistive sensors with up to 3 programmable output signals that fit in Gimatic C shaped sensor slots. When the programmed switched position is reached, the corresponding output is activated, and its status is indicated visually with the LEDs.

88.00
Each
Quantity:
PRO SN3N215G
  • Easy single button programming. See the Programming Procedure linked document for further information.
  • Highly accurate, makes this ideal for part confirmation/mid-stroke detection for any size gripper.
  • Ideal for applications where space is limited and multiple output signals are needed, up to 3 positions.
  • Each output can be independently configured to Normally Open or Normally Closed and is clearly identified by LEDs.
  • Wide +/- 30mm sensing range (relative to the magnet and the sensor).
  • 5-Wire cable with M8 Connector
  • 12/24 Vdc, 0.2 A, PUR round cable 5x0.09mm2 length 1.5 meters with set screw
  • Adaptor #7527 is available for combining the single 5-pin M8 into 3x3pin M8 connectors.

Sensors

Style
Gimatic SN
Type
Teachable PRO
Signal
PNP
7527 Y M8 Extension Cable for Gimatic PRO & SBM Sensors 1x 8 Pin Female 3x 3 Pin Male

Use this extension cable to connect Gimatic PRO teachable sensors to a SBM sensor box.

Item #:
CFGM8CMGM8X3Y
54.00
Each