Z6_I8001C80MGFH50A5NPQ4Q39ID5
Z7_I8001C80MGFH50A5NPQ4Q39HR2

S2K Commerce - Products Dropdown

Actions
Loading...
Z7_I8001C80MGFH50A5NPQ4Q39HR1

S2K Commerce - Shopping Cart

Actions
Loading...
Z7_I8001C80MGFH50A5NPQ4Q39HR3

Shot Rejection Parts Diverting Conveyor

Shot Rejection Parts Diverting Conveyor

Eliminate the need to manually inspect and remove bad parts. Many of today's molding presses come complete with “Process Control Output”—a feature that can signal the production of a bad shot. Shot Rejection Part Diverters are used to remove bad shots from good shots. They are normally fitted onto an under press conveyor.

How does it work? On one side of the diverter is a panel which is hinged on the bottom. If a bad part is molded, a Process Control Tie-In signals two air cylinders to activate. The cylinders push the top of the hinged side panel under the mold, creating a chute to remove the bad parts. Once the parts are removed, the panel immediately returns to the upright position, which allows the next shot of parts to fall onto the conveyor.