S2K Commerce - Shopping Cart


S2K Commerce - Products Dropdown


Extruded Aluminum Frame Conveyors, Z-Belt

Standard combined lengths: 7'–15' at 6" increments

Standard belt widths: 6", 12", 18", 24"
Available belt widths: 6"-26" at 2" (50mm) increments
Widths 18" and over require split belt cleat




  • Anodized extruded aluminum frame with side channels that accept standard 3/8" hex head bolts/nuts See Detailed Illustration
  • 0-60° adjustability from horizontal to incline sections with built-in angle indicator
  • Anodized aluminum side rails 4" high, 90° overlapping the belt 1¼" per side
  • New heavy-duty powder-coated steel leg sets with 4" locking swivel castors. Extruded aluminum leg sets available.
  • 110 Volt 1/3hp AC motor with variable speed standard
  • Gear reducer is sealed and permanently lubricated requiring no service
  • 4-40 FPM variable speed drive
  • Direct drive power transmission
  • 50 lb. maximum load
  • V-guide belt guidance
  • Automatic spring loaded belt tensioning
  • Laced, flat PVC belting (blue), FDA approved material
  • 210°F belt temperature resistance
  • Units up to 20' long are shipped fully assembled

Common Options:

  • Extruded Aluminum Conveyor Options
  • 2-20 FPM or 7-70 FPM are available at no charge
  • Endless belting is available at no charge
  • Alternate belting is available on all EA models. View all the options here.
  • Side rail extensions for part containment
  • Polycarbonate rail covers
  • Chilled air or ambient air blowers for part cooling
  • Stainless steel discharge chute
  • Deionizing blowers to eliminate static electricity and prevent particles from sticking to parts
  • Box filling by cycle count or weight
  • Alternate motor locations
  • *When Ordering: Minimum length of motor frame section is 3'. Minimum length of intermediate and non-motor sections is 2' each. Total combined lengths of all frame sections cannot exceed 15'.

BW = Belt width
Usable belt width measurement and rail options